Handling your firearm safely

Cleaning firearms

Firearms are made of metal and wood or composite material. Regular cleaning and maintenance will keep your firearm safe and reliable.

It is essential that the barrel is free from obstruction.

Before storing your firearm you should clean the barrel with a rod, clean patches and solvent. Where possible, insert the cleaning rod from the chamber end of the bore to avoid damaging the muzzle.

When you have cleaned the barrel push an oily patch through it. Clean the action and the outside of the firearm. Wipe all metal parts with a lightly oiled rag.

When you are taking your firearm out for use, point it in a safe direction then check that it is not loaded. Push a clean patch through the bore and check that the barrel and action are clean and dry. Grease or oil in the action can cause a misfire. If either gets into the barrel, they can cause it to bulge or burst.

When hunting, take cleaning gear with you - at least a pullthrough, patches and oil. At the end of each day clean and oil the barrel.

Cleaning a firearm. The rod is inserted from the chamber end of the barrel.

If you have any doubts about a safety catch - take it to a gunsmith!

Correct ammunition

It is important to use the correct ammunition for your firearm. Even if you have the right calibre, it may not necessarily be the right ammunition. The chambering may be unsuitable or the action may not be strong enough e.g. .22 short, .22 long, .22 long rifle and .22 magnum are all .22 rimfire, yet are not suitable for every .22 rimfire rifle.

If the wrong ammunition is chambered it may be too big to allow the action to close. If it is too small it can slip so deeply into the chamber that it is out of reach of the firing pin. Worse still, it may fit, allow the action to close and fire the wrong calibre bullet. This could burst the barrel or
cause a dangerous blowback of gas in the shooter’s face.

Numbers that show the calibre are stamped on the base of the cartridge case. However, sometimes there are other numbers or words to identify one cartridge from another. You should know the correct and full description of the cartridges your firearm requires. To make sure there is no mistake, use that description when ordering ammunition, and also check the description on the ammunition packet.

Many shooters reload their own cartridges because of economy and accuracy. Brass cartridge cases are sometimes pressed through resizing dies to become a type different from the original e.g. a 30.06 Springfield case may become a .270 cartridge. So, the information stamped on the base of the case can be misleading. A new shooter would be wise to use only factory-made ammunition purchased from a shop.

Do not use old or corroded ammunition. It can cause misfires, burst cases and block the barrel. Wet or damp ammunition can increase pressure in the firearm and could also damage and injure. Never attempt to dry wet ammunition by heating it.